Crosley Refrigerator Especificaciones

TOP-MOUNTREFRIGERATORTable of Contents...2www.crosley.com®2212430

10Setting the Control(s)For your convenience, the refrigerator controls are preset at the factory. Controls for the refrigerator and freezer are locat

11REFRIGERATOR FEATURESYour model may have some or all of these features. Features that can be purchased separately as product accessories are labeled

12To remove and replace the shelf track:1. Remove the shelf track by lifting both sides of the track slightly and pulling the track straight out.2. Re

13To replace crisper(s) cover:NOTE: Before reinstalling the cover, make sure the U-shaped reinforcement bar is reinstalled in the front edge of the cr

14 To turn the ice maker off: Automatic turn off: As ice is made, the ice cubes will fill the ice storage bin, and the ice cubes will raise the wire

15Pull-out Freezer Floor (on some models)To remove and replace the freezer floor:1. Lift both back “fences” up and out.2. Remove the freezer floor by

16To adjust the utility compartment or tray:1. Lift the front slightly and slide to desired position.2. Lower front to lock into place.Flip-up Door Sh

17Power InterruptionsIf the electricity in your house goes off, call the power company and ask how long it will be off.1. If the power will be out for

18The motor seems to run too much Is the room temperature hotter than normal?Expect the motor to run longer under warm conditions. At normal room temp

19There is interior moisture build-up Are the air vents blocked in the refrigerator?Remove any objects from in front of the air vents. Refer to “Ensur

2TABLE OF CONTENTSREFRIGERATOR SAFETY... 3INSTALLING YOUR REFRIGERATOR...

CROSLEY® REFRIGERATOR WARRANTY ONE-YEAR FULL WARRANTY ON REFRIGERATORFor one year from the date of purchase, when this refrigerator is operated and ma

3REFRIGERATOR SAFETYProper Disposal ofYour Old RefrigeratorIMPORTANT: Child entrapment and suffocation are not problems of the past. Junked or abandon

4INSTALLING YOUR REFRIGERATORUnpacking Your RefrigeratorRemove shelves from the shipping position (shelves are shipped upside down):1.Grasp the front

5Electrical RequirementsBefore you move your refrigerator into its final location, it is important to make sure you have the proper electrical connect

66. Fasten shut-off valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄ in. drilled hole in the water pipe and that was

7Refrigerator Doors: Removing, Reversing (optional) and ReplacingTOOLS NEEDED: ⁵⁄₁₆ in. hex-head socket wrench, No. 2 Phillips screwdriver, flat-head

8Door and hinge removal⁵⁄₁₆” Hex Head Hinge Screw1.Unplug refrigerator or disconnect power.2.Open refrigerator door and remove base grille from the bo

94. Use a screwdriver to adjust the leveling screws. Turn the leveling screw to the right to raise that side of the refrigerator or turn the leveling